Avaya AWH75 Manual Del Usuario página 6

Setup 5
with other AVAYA telephones
Caution: It is important for correct and safe operation that the base cord
is installed into the proper jack of your telephone. Follow these instructions
carefully, especially if your telephone has two jacks where the handset was
attached. Be sure to note or mark which jack was used for the handset.
1
24
Configuration
Dial
{see page 15}
4
Optional
Lifter
IntelliStand
™
IntelliStand
off
IntelliStand
on
10
6
7
24
Optional
25
Lifter
Be sure to connect
this plug into the
jack where the
handset was
connected.
Optional
Lifter
™
Set the IntelliStand
switch to IntelliStand off
–
( ) if you want to control
the handset lifter with
the call control button
on your headset.
Set the IntelliStand
switch to IntelliStand on
=
( ) if you want the
handset to automatically
pick up when you take
the headset off the
charging cradle.
Charging
Positioning
1 2
"
The minimum recommended separation distance is shown above.
IMPORTANT: Incorrect positioning can cause noise and interference problems.
1. Slide the headset into the charging
cradle. The earpiece with the micro-
phone goes into the cradle.
2. Gently press down on the the head-
set to ensure that the headset is in
the correct position. The amber
charge indicator light on the base
will flash while charging and will
change to solid amber when fully
charged.
• 20 minutes = minimum charge
to continue setup
• 3 hours = full charge
11