Teac T-R610 Manual Del Usuario página 5

B
AM Indoor Loop Antenna
The high-performance AM loop antenna provided with this
unit is sufficient for good reception in most areas.
To stand the loop antenna on a surface, fix the claw to the
slot in the antenna base.
Connect the loop antenna's wires to the AM antenna
terminals.
Place the antenna on a shelf or hang it on a window frame,
etc., in the direction which gives the best reception. Keep all
other wires such as power cords, speaker wires or
interconnect wires as far away as possible from the antenna.
< If the AM loop antenna provided does not deliver sufficient
reception (often due to being too far from the transmitter or
in a concrete building, etc.), it may be necessary to use an
outdoor AM antenna.
Use either a high quality commercial AM antenna or, if not
available, an insulated wire more than 5 m long, strip one
end, and connect this to the terminal as shown.
The antenna wire should be strung outdoors or indoors near
a window. For better reception, connect the GND terminal
to a reliable ground.
Note:
Even when using an outdoor AM antenna, do not
disconnect the AM loop antenna.
All manuals and user guides at all-guides.com
C
D
• When you tune in a station, the input selector of the A-
• You can use the "UR" remote control unit RC-592B
Note:
E
• When the system is damaged by some electrical shock.
• When the power is irregular or has electrical noises.
F
LINE OUT jack
Analog 2-channel audio signal is output from this jack.
Connect this jack to the TUNER jack of the amplifier (A-
R610) with an RCA cable.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
REMOTE CONTROL jack
If you have TEAC A-R610, convenient system control
operations are available:
R610 is set to "TUNER" automatically.
(provided with A-R610) to operate this unit.
Connect the REMOTE CONTROL jack (A or B) to the
REMOTE CONTROL jack (A or B) of A-R610 with the
provided remote control connection cord.
The remote control unit is not provided with this unit.
RESET
In the following cases, function buttons may not work
properly.
In these cases, press the RESET switch once or twice with a
pencil or a ball-point pen lightly.
All the settings kept in memory (such as preset stations and
timer settings) will be erased.
AC Power Cord
After all other connections are complete, connect the plug
to the AC wall socket.
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord.
5