Maintenance Table; Problem Identification - Stiga ST 700 Li 4 Serie Manual De Instrucciones

Quitanieves conducido de pie
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 120
• Poor maintenance.
• Modification to the machine.
• Use of non-genuine spare parts (adaptable
parts).
• Use of accessories not supplied or approved by
the manufacturer.
The warranty does not cover:
• Maintenance operations (described in the
instruction manual).
• Normal wear and tear of consumables.
• Normal wear and tear.

13. MAINTENANCE TABLE

Safety checks/check controls
Always check the electric devices are intact and working properly
Check that the impeller rotates freely
Apply silicone spray on the impeller, to avoid ice formation
Check all the screw connections are tight. Tighten, if necessary.
Check the starter lever is only activated on
release of the disengaged starter lever
General cleaning and inspection

14. PROBLEM IDENTIFICATION

PROBLEM
1. No start.
2. The motor barely
rotates.
3. The motor stops
suddenly.
Intervention
PROBABLE CAUSE
Battery is not inserted or is
inserted incorrectly.
Overload protection activated.
The impeller is on and the
motor cannot start.
Impeller clogged, blocked by
obstacles or damaged.
The capacitor is faulty.
Electric part malfunction.
Overload protection activated
• Deterioration in the appearance of the machine
due to use.
• Any ancillary expenses related to the enforcement
of the warranty, such as costs incurred to travel
to the user's location, transfer of the machine to
the Dealer, rental of replacement equipment or
calling of independent enterprises to perform
maintenance work.
The user is protected by his or her own national
legislation. The user's rights under the national
laws or his or her own country are not in any way
restricted by this warranty.
Before and after each use
Check that the battery is
correctly inserted.
Wait a few seconds for automatic reset.
Immediately release the start
control and remove the obstacle.
Try and switch on again.
Clean the impeller and the chute.
Remove any dirt or foreign
bodies. Replace if damaged.
Call assistance or the dealer.
Call assistance or the dealer.
Wait 10 minutes and try again.
EN - 13
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
SOLUTION
Paragraph
6
6
6
6
4
5
8.3

Publicidad

Tabla de contenido
loading

Tabla de contenido