Connections; Connection Panel; Rear Panel; Front Panel - Pioneer DJM-400 Manual De Instrucciones

CONNECTIONS

CONNECTIONS

CONNECTION PANEL

Rear panel

POWER
OFF ON
AC IN
17
1. POWER switch
2. STEREO/MONO selector switch
When switch is set to the [MONO] position, master output is in
monaural.
3. MIC2/AUX(R) input connector
Ø6.3 mm phone-type input connector. Use for microphone input, or
for right (R) channel of component with line level output.
4. MIC/AUX input selector switch
When this switch is set to [AUX], the MIC1 and MIC2 input connectors
function as AUX(L) and AUX(R) input connectors.
5. MIC1/AUX(L) input connector
Ø6.3 mm phone-type input connector. Use for microphone input, or
for left (L) channel of component with line level output.
6. Signal grounding terminal (SIGNAL GND)
Use to connect ground wires from analog players.
This is not a safety grounding terminal.
7. Channel 1 CONTROL connector
Ø3.5 mm mini-phone type connector. Connect to control connector
of the DJ CD player connected to channel 1 inputs.
When this connection is made, the DJ mixer's fader lever can be used
to perform fader start play and back cue on the channel 1 DJ CD
player.
8. Channel 1 CD input connectors (CD)
RCA type line level input connectors.
Use to connect a DJ CD player or other component with line level
output.
9. Channel 1 PHONO/LINE input connectors
RCA type phono level (for MM cartridge) or line level input
connectors.
Select function using channel 1 PHONO/LINE selector switch.
10. Channel 1 PHONO/LINE selector switch
Use to select function of channel 1 PHONO/LINE input connectors.
4
<DRB1404>
En
1 2 3
MONO STEREO
1 2
MASTER
OUT L L
LINE PHONO
R R
16 15 14
4 5
MIC2 MIC1
AUX(R) AUX(L)
MIC AUX
PHONO PHONO
CD
LINE LINE
L
LINE PHONO
R
CONTROL
13 12 11 10 9
11. Channel 2 CONTROL connector
Ø3.5 mm mini-phone type connector. Connect to control connector
of the DJ CD player connected to channel 2 inputs.
When this connection is made, the DJ mixer's fader lever can be used
to perform fader start play and back cue on the channel 2 DJ CD
player.
12. Channel 2 CD input connectors (CD)
RCA type line level input connectors.
Use to connect a DJ CD player or other component with line level
output.
13. Channel 2 PHONO/LINE input connectors
RCA type phono level (for MM cartridge) or line level input
connectors.
Select function using channel 2 PHONO/LINE selector switch.
14. Channel 2 PHONO/LINE selector switch
Use to select function of channel 2 PHONO/LINE input connectors.
15. MASTER OUT 2 output connectors
RCA type unbalanced output.
16. MASTER OUT 1 output connectors
RCA type unbalanced output.
17. Power inlet (AC IN)
Use the accessory power cord to connect to an AC power outlet of the
proper voltage.
18. Headphones jack (PHONES)
Use to connect stereo headphones equipped with Ø6.3 mm stereo
headphones plug.
www.audiovias.com

Front panel

6 18
CD
SIGNAL
GND
CONTROL
8 7