Connections; Connection Panel - Pioneer DJM-700-S Manual De Instrucciones

01_DJM-700_En.book 5 ページ ２００７年７月１０日 火曜日 午後８時４１分

CONNECTIONS

CONNECTIONS

CONNECTION PANEL

1
POWER
18
1 POWER switch
2 BOOTH monitor output connectors
RCA-type booth monitor output jack.
The sound level from these connectors is controlled independently
by the BOOTH MONITOR LEVEL dial, regardless of the position of
the MASTER LEVEL dial.
3 Recording output connectors (REC)
RCA type output connectors for recording.
4 PHONO input connectors
RCA type phono level (MM cartridge) input connectors.
Do not use for inputting line level signals.
5 LINE input connectors
RCA type line level input connectors.
Use to connect a cassette deck or other line level output
component.
6 CD input connectors
RCA type line level input connectors.
Use to connect a DJ CD player or other line level output
component.
7 CONTROL connectors
Ø3.5 mm mini-connector. Use to connect to the control connector
of a Pioneer DJ CD player.
When the connectors are connected, the DJM-700-S/DJM-700-K's
fader can be used to perform start/stop on the DJ CD player.
8 Two microphone input jacks (MIC 2)
Connect microphones equipped with phone-type plugs.
9 Signal grounding terminals (SIGNAL GND)
Reduces noise when connecting an analog turntable.
10 MIDI OUT connector
DIN type output connector.
Use to connect to other MIDI component (see P. 21).
2 3 4
CH-4
BOOTH REC PHONO LINE PHONO
L L
OFF
ON
1 GND 2 HOT
R R
3 COLD MASTER1
R L
MASTER2
MASTER
R L
ATT.
-6dB -3dB 0dB
17 16
5 6
CH-3 CH-2 CH-1
LINE PHONO CD LINE CD
L L L
CONTROL
R R R
SIGNAL GND
SEND
RETURN
DIGITAL OUT
R L R L
(MONO) (MONO)
fs(Hz)
48k 96k
15 14 13 12
11 DIGITAL OUT connector
RCA type digital coaxial output connector.
Master audio digital output.
12 Sampling frequency selector switch (fs 48 k/96 k)
Use to set the sampling frequency of the digital output to 96 kHz/
24-bit format or 48 kHz/24-bit format.
• Turn power off before changing this switch position.
13 RETURN connectors
Ø6.3 mm phone-type input connectors.
Use to connect to the output connectors of external effectors or
similar components.
When the L channel only is connected, the L channel input is
simultaneously input to the R channel.
14 SEND output connectors
Ø6.3 mm phone-type output connectors.
Use to connect to the input connectors of external effectors or
other similar components. When the L channel only is connected,
a L+R monaural signal is output.
15 Master output attenuator switch (MASTER ATT)
Use to attenuate the level of the master 1 and master 2 outputs.
Attenuation can be set to 0 dB, –3 dB, or –6 dB.
16 MASTER 2 output connectors
RCA type unbalanced output.
17 MASTER 1 output connectors
XLR type (male) balanced output.
• When using a cord with RCA-type plug, users are recommended
to connect the plug directly to the MASTER 2 connectors
without using an XLR/RCA converter plug.
18 Power cord
Connect to ordinary AC outlet.
7 8 9
MIC 2
CONTROL
MIDI OUT
11 10
En
5