Displaying Spectrum Analyzer; Switching Disc Mode; Operating An External Audio Processor; (Optional) - Alpine CVA-1014 Manual Del Usuario

Other Useful Features
SOURCE/
POWER
bass engine
TITLE
g f BAND/
TEL.

Displaying Spectrum Analyzer

When using the optional expansion box (KCE-
104V), you can use this function.
After carrying out steps 1 to 3 of "To display the
SETUP screen" (page 33), perform the operation
shown below.
1
When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2
Press preset 5 to activate the SYSTEM setting
mode. Press preset 5 again to select SPE.ANA.
3
Press g or f to select ON or OFF.
Set to ON, then press V.SEL to select the
Spectrum Analyzer display (refer to
"Simultaneous Operation" on page 43).
For any other settings, press preset 5 or another
preset button.
4
After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTE
When an external Audio Processor is connected,
Spectrum Analyzer is displayed only in AM or FM mode.
42
-EN
All manuals and user guides at all-guides.com
MUTE/ Preset buttons
SETUP (1through 3)
Preset 5 V.SEL

Switching Disc Mode

Use this function when connecting the optional
CD/DVD player, changer.
1
Press BAND/TEL. to switch the Disc mode in the
CD/DVD changer mode.
Example
→ External CD
Changer ←
Operating an External Audio
Processor (Optional)
You can operate a connected external audio
processor from the CVA-1014.
1
When an external audio processor is connected,
press bass engine to activate Audio Processor
mode.
2
Press a preset button (1 through 3) to select
the desired function, and then g or f to
adjust settings.
When the ERA-G310/ERA-G320/CDA-5755/
PRA-H600/PXA-H510/PXA-H900 is connected
preset 2: Subwoofer phase control
(NORMAL/REVERSE)
preset 3: Recalling the stored settings
(Preset 1 through 6)
When the PXA-H400 is connected
preset 1: Bass/Treble control (-7 ~ +7)
preset 3: Recalling the stored settings
(Preset 1 through 4)
When the PXA-H700/PXA-H701 is connected
preset 1: Setting the MX mode
(MX compatible sources only)
preset 2: Subwoofer phase control
(NORMAL/REVERSE)
∗
When the monitor is open: displayed in the monitor
1
0° ↔ 180°
When the monitor is closed: displayed in the sub-display
NOR ↔ REV
∗
When the CDA-5755 is connected: (Preset 1 through 4)
2
3
Press bass engine to return to normal mode.
NOTE
For details about external audio processor operation, see
the owner's manual of the external audio processor.
→ External DVD
DVD changer ←
∗
1
∗
2
∗
1