Stryker 5050 Manual De Uso página 15

R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e f f o o o o t t r r e e s s t t
W W A A R R N N I I N N G G
• Always hold the footrest while repositioning to make sure that it does not fall to the lowest position. Patient or operator
injury or device damage may occur.
• Do not stand on the footrest. The product may tip and result in patient or operator injury.
N N o o t t e e - - The leg section must be down to adjust the footrest. Rotate the footrest halfway up to the leg section to adjust the
height.
To raise the footrest:
1. Rotate the footrest halfway up, then slide it toward the butt section until you reach the desired height.
2. While pulling the footrest toward you, rotate it down to a horizontal position.
3. The footrest will drop into the next lower position.
To lower the footrest:
1. While grasping the footrest, rotate it up and push back on it.
N N o o t t e e - - The footrest will drop down after it clears the latch.
2. Rotate the footrest to a horizontal position.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e f f o o o o t t s s e e c c t t i i o o n n i i n n d d e e p p e e n n d d e e n n t t ( ( c c h h a a i i r r ) ) m m o o d d e e
C C A A U U T T I I O O N N - - Always support the foot section while repositioning to make sure that it does not fall. Patient or operator injury
or device damage may occur.
To put the foot section in dependent (chair) mode, rotate the red handle (A), located on both sides of the foot section,
toward the head end of the product (Figure 6).
5050-009-005 Rev C.0
A
F F i i g g u u r r e e 5 5 – – F F o o w w l l e e r r b b a a c c k k r r e e s s t t
A
11 EN