Stryker 5050 Manual De Uso página 17

R R e e m m o o v v i i n n g g a a n n d d i i n n s s t t a a l l l l i i n n g g t t h h e e m m a a t t t t r r e e s s s s
To remove the mattress, from the head end of the product, pull on the head end of the mattress to pull the mattress away
from the V V e e l l c c r r o o ® on the Fowler backrest and midsection. Continue to pull the mattress toward the head end of the product
to release the mattress from the foot section sliding tabs.
N N o o t t e e - - The foot section sliding tabs keep the foot section of the mattress close to the litter surface during articulation.
To install the mattress, slide the pockets on the foot end back over the sliding tabs. Place the mattress on the rest of the
litter surface. Press firmly on the Fowler backrest and midsection to secure the V V e e l l c c r r o o ® strips.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e e e n n h h a a n n c c e e d d c c l l e e a a r r a a n n c c e e h h e e a a d d p p i i e e c c e e
W W A A R R N N I I N N G G
• Always support the patient's head when you position the headpiece or the Fowler backrest. Patient injury may occur.
• Do not reach between the side of the head extension and the articulating headpiece to pull the release handles.
Operator injury may occur.
• Always keep fingers away from jointed areas when you adjust the headpiece. Operator injury may occur.
To adjust the articulating headpiece, grasp either handle under the headpiece and squeeze.
• Handle (A) (Figure 9) releases one latch and rotates the headpiece on axis (C) (Figure 8).
• Handle (B) (Figure 9) releases the other latch and rotates the headpiece on axis (D) (Figure 8).
5050-009-005 Rev C.0
A
F F i i g g u u r r e e 7 7 – – R R e e d d r r e e l l e e a a s s e e k k n n o o b b
13 EN