Stryker 5050 Manual De Uso página 16

A
F F i i g g u u r r e e 6 6 – – P P o o s s i i t t i i o o n n o o f f r r e e d d h h a a n n d d l l e e i i n n d d e e p p e e n n d d e e n n t t ( ( c c h h a a i i r r ) ) m m o o d d e e
N N o o t t e e - - In dependent (chair) mode, the foot section articulates with the Fowler backrest when the product moves from the
sitting to supine position.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e f f o o o o t t s s e e c c t t i i o o n n i i n n i i n n d d e e p p e e n n d d e e n n t t m m o o d d e e
C C A A U U T T I I O O N N - - Always support the foot section while repositioning to make sure that it does not fall. Patient or operator injury
or device damage may occur.
To put the foot section in independent mode, rotate the red handle (A), located on both sides of the foot section, toward the
foot end of the product (Figure 6).
To reposition the foot section, hold the foot end and pull the red handle (A) toward you. Lift or lower the foot section to the
desired position and lock the red handle in place.
To reset the foot section to the dependent (chair) mode, support the foot section and rotate the red handle (A) toward the
head end of the product. Lift or lower the foot section until the foot section locks in place. Raise and lower the Fowler
backrest and make sure that the foot section moves with the Fowler backrest.
N N o o t t e e - - In independent mode, the foot section articulates to any position independent of the Fowler backrest.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p u u s s h h b b a a r r ( ( M M o o d d e e l l 5 5 0 0 5 5 0 0 ) )
To raise or lower the push bar, support the push bar and pull the red release knob (A) (Figure 7). Swing the push bar into
the full up or down position until it latches.
EN 12 5050-009-005 Rev C.0