Final Installation - Harbor Breeze TG44LW3D1RS Manual De Instrucciones

FINAL INSTALLATION

1. Lift canopy (B) to mounting bracket (C) again,
aligning slotted holes in canopy (B) with loosened
canopy mounting screws (G) in mounting bracket
(C). Twist canopy (B) clockwise to lock. Re-insert
the two canopy mounting screws (G) previously
removed (Step 4, page 7) and tighten all canopy
mounting screws (G) securely.
2. Align slots on glass shade (K) with protrusions on
underside of motor housing (D). Turn glass shade
(K) clockwise until it no longer turns.
NOTE: Pull down gently on the glass shade (K) to
make sure it is secured completely.
3. If you wish to use the remote control bracket from
remote pack (O), install screws from remote pack
(O) through bracket and into the desired installation
site. The remote control transmitter from remote
pack (O) rests inside the bracket.
1
Downrod
Option
B
2
D
K
3
Wall
15
Closemount
Option
G
G
B
D
D
slot
Bracket
Screws
Remote Control
Bracket