Material Resistance; Storage And Caring For The Device - Beurer IH20 Instrucciones De Uso

fully immerse all parts, such as atomizer,
mouthpiece, nosepiece, adult mask and
child mask. The air hose [9] must not be
placed in the vinegar solution.
NOTE: Dismantle the atomizer by twist-
ing the upper section counter-clockwise
against the medicine container [12].
• Submerge the components in the vinegar
solution for 30 minutes.
• Remove the components and discard the
solution. Rinse the components with wa-
ter.
Boiling Water Method
• The atomizer should be taken apart and
placed together with the mouthpiece and
nosepiece in boiling hot water for at least
10 minutes. Avoid the parts coming into
b) Nebulizer
• Clean the casing of the main unit daily by using a damp cloth, to which you can apply a
little detergent if necessary.
• Keep the unit dust-free.
8.2

Material Resistance

As with all plastic components, frequent use and cleaning of the atomizer and the accesso-
ries can lead to a certain amount of wear. Over time, this can alter the aerosol properties
and may eventually affect the efficiency of therapy. We therefore recommend that you re-
place the atomizer and the accessories at the latest once a year. In case of frequent use
earlier replacement might be necessary.
8.3

Storage and Caring for the Device

DANGER
• Always unplug this product immediately after use and make sure it is not accessible to
children.
• The unit and power cord must be protected and stored away from sources of heat. (e.g.
stoves, heating radiators).
WARNING
• The IH 20 Nebulizer must only be used with suitable Beurer atomizers and with the appro-
priate Beurer accessories. The use of other atomizers and accessories may damage the
device and can impair therapeutic efficiency.
All manuals and user guides at all-guides.com
Drying
• After disinfection carefully dry all compo-
• Place the individual components on a
• Once all components are fully dry, reas-
16
contact with the hot base of the pot. The
face masks [14 and 15] and air hose [9]
must not be placed in hot water! The face
masks [14 and 15] must be disinfected
using the "Vinegar method"
nents using a soft cloth.
dry, clean and absorbent surface and al-
low to dry completely (for at least 4
hours).
semble the atomizer [10] and place the
components in a dry, sealed container.