Inserting The Battery; How It Works - LaserLiner AC-Tracer Manual Del Usuario

Sender TX
2
3
1

Inserting the battery

Open the battery compartment
and insert battery according
to the symbols. Be sure to pay
attention to polarity.

How it works

1
Measurement is performed using one transmitter and one receiver. The transmitter feeds
signals into the cable to be checked. The signal is a modulated current that creates an
electromagnetic field about the conductor. The receiver recognises this field and is then
able to find and locate cables, sockets etc. with this signal.
2 Sender TX: Set-up
The tracer requires no battery and is operated by the power supply. This means only live
cables can be tested. Before using the tracer, connect the required lead (4, 5, 6), ensuring
correct polarity. The device is operational when indicator lamp (1) is on.
3 Finding cables, sockets etc. in coherent electrical circuits.
!
Measurement under voltage! It is essential that you follow the safety instructions.
4
– +
5
1 ON indicator lamp
2 Connecting socket, red +
3 Connecting socket, black –
4 Euro connector
5 E 27 Lamp adapter
6 UK plug
6
AC-Tracer
1 x 9V 6LR61
(9-volt block)
11
EN