Charging Procedure/Operating Instructions; Cleaning Instructions - RIDGID Micro CA-300 Manual Del Usuario

micro CA-300 Inspection Camera
Figure 22 - Label on Charger
Figure 23 - Label on Battery
4. Select an appropriate location for the char-
ger before use. Check work area for:
• Adequate lighting.
• Clear, level, stable, dry place for charg e r.
Do not use the device in wet or damp
areas.
• Proper operating temperature range.
The charger and battery must both be
between 32°F (0°C) and 122°F (50°C) for
charging to begin. If the temperature
of either is outside of this range at any
point during charging, the operation
will be suspended until brought back
to the correct temperature range.
• Appropriate power source. Check to
see that the plug fits correctly into the
desired outlet.
• Sufficient ventilation. T he charger needs a
clearance of at least 4" (10 cm) on all sides
to maintain a proper operating tempera-
ture.
5. Plug cord into charger.
6. With dry hands, plug charger into the appro-
priate power source.
18
Charging Procedure/
Operating Instructions
WARNING
Always wear eye protection to protect your
eyes against dirt and other foreign objects.
Follow operating instructions to reduce the
risk of injury from electrical shock.
NOTE! New batteries reach their full capacity
after approximately 5 charging and
discharging cycles.
1. Set up charger according to the Charger
Inspection and Set Up section.
2. The charger conducts a 1-second life test
during which the LED blinks from red to
green. The charger then goes into stand-
by mode in which the LED is OFF.
3. With dry hands, insert the battery pack
onto the charger. The battery pack will
begin charging automatically. While the
battery is charging, the red LED will glow
solid.
4. When the battery is fully charged, the
green LED glows solid. Remove the bat-
tery. Once the battery is charged, it may
remain on the charger until it is ready to
be used. There is no risk of over-charging
the battery. When the battery has been
fully charged, the charger automatically
switches to retention charging.
5. With dry hands, unplug the charger from
the outlet once charging is complete.

Cleaning Instructions

WARNING
Unplug the charger before cleaning. Do not
use any water or chemicals to clean charger
or batteries to reduce the risk of electrical
shock.
1. If present, remove battery from charger.
2. Remove any dirt or grease from the ex-
terior of the charger and battery with a
cloth or soft non-metallic brush.