Inserting/Replacing The Battery; Setting Up The Measuring Tool - CST/BERGER LASERMARK GIZLT-3 Manual Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
Assembly

Inserting/Replacing the Battery

Cross-line Laser
Alkali-manganese batteries are recommended for the measuring tool.
– Open the battery compartment of the measuring tool.
– When inserting the battery, pay attention to the correct polarity
according to the representation on the inside of the battery compart-
ment.
– Always replace all batteries at the same time. Only use batteries from
one brand and with the identical capacity.
Remove the batteries from the measuring tool when not
using it for extended periods. When storing for extended periods,
the batteries can corrode and discharge themselves.
Laser Receiver
Using alkali-manganese batteries is recommended for operation of the
laser detector.
– Open the battery compartment 15 on the backside of the laser
detector.
– When inserting the battery, pay attention to the correct polarity
according to the representation on the inside of the battery compart-
ment.
Remove the battery from the laser receiver when not using it
for longer periods. When storing for longer periods, the battery
can corrode and discharge itself.
– Replace the battery as soon as the battery indicator 21 lights up.

Setting Up the Measuring Tool

– Position the measuring tool on a firm surface.
or
– Put the measuring tool into the mounting bracket 7. (see figure A)
The mounting bracket can either be mounted to a standard tripod or
screwed to a wall.
The measuring tool can be rotated up to 90° using the mounting
bracket's graduated ring 8.
20 | English
2 610 A13 773 • 17.2.10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lasermark gizlt-3e

Tabla de contenido