Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
veHIcLe:
Antenna
Adjustable front
wheel suspension
Shock absorbers
Wheel rims
reMoTe coNTroLLer:
Antenna
Reverse switch
for steering
Reverse switch for
the speed control
Power / charge control LED
1. Remove the cover in the
direction indicated by the
arrow.
caution: Before recharging and after every use, always wait 10 to 15 minutes for the battery to cool down This is in order to avoid damage to the vehicle's battery.
Never leave the vehicle unattended while charging.
1. Switch off the vehicle and remote control. (Fig. 1)
2. Disconnect the battery cable from the vehicle. Do not force. (Fig. 2)
3. Remove the battery from the vehicle as shown, first removing the retaining clips. (Fig. 3)
4. Insert the mains adapter into a plug socket. Connect the NiMH battery to the charger.
The red LED lights up. Do not force. (Fig. 4)
5. The charging process takes around 6 hours when the battery is completely drained. The red
LED turns to green when the battery is fully charged. Do not allow the battery to charge for
longer than 6 hours due to safety reasons.
6. Remove the charger from the plug socket and disconnect the battery from the charger.
7. Reinsert the battery in the vehicle and fasten it with the retaining clips. (Fig. 5)
8. Before use, carefully reconnect the cables on the vehicle. (Fig. 6)
After a charging period of approx. 6 - 10 hours, the vehicle will drive for about 6 to
10 minutes. We recommend using a suitable fast charger, available as a revell
accessory in all good specialist stores.
vehicle and remote control
Inserting the batteries
2. Insert eight 1.5 V AA batteries according to
the polarity in the battery compartment.
recharging the vehicle
High performance shock absorbers
Compartment for NiMH battery
AcceSSorIeS:
Antenna holder
Steering
Trim control for
steering
Trim control
for speed
Speed control
Battery
compartment
3. Close the battery
compartment cover
Fig. 1
Fig. 4
ON/OFF
switch under
the bonnet
230 V AC adapter
Vehicle battery
NiMH 7.2 V / 1100 mAh
ON/OFF switch
4. Green and red power LEDs on the remote
control indicate: fully charged.
Fig. 2
Fig. 3
Fig. 6
Fig. 5
7
Publicidad
Tabla de contenido
