Before Returning For Repairs - DieHard DH-200M Manual Del Usuario

PROBLEM
Charger will not turn on
when properly connected.
The battery is connected
and the charger is on, but is
not charging.
The measured current is
much lower than what was
selected.
16.

BEfORE RETURNINg fOR REPAIRS

16.1 When a charging problem arises, make certain that the battery is capable
of accepting a normal charge. Double check all connections, the A.C. outlet
for a full 120-volts, the charger clips for correct polarity and the quality of
the connections from the cables to the clips and from the clips to the battery
system. The clips must be clean.
16.2 When a battery is very cold, partially charged or sulfated, it will not draw the
full rated amperes from the charger. It is both dangerous and damaging to a
battery to force higher amperage into it than it can effectively use
in recharging.
16.3 When an UNKNOWN OPERATING PROBLEM arises, please read the
complete manual and call the customer service number for information that will
usually eliminate the need for return.
If the above solutions do not eliminate the problem or for information about troubleshooting
or replacement parts, call toll-free from anywhere in the U.S.A.
7:00 am to 5:00 pm Central Time Monday through Friday
POSSIBLE CAUSE
A.C. outlet is dead.
Poor electrical connection.
Clips are not making a good
connection.
The charger reached the
maximum voltage and is
reducing the current.
1-800-732-7764
15
• •
REASON/SOLUTION
Check for open fuse or
circuit breaker supplying
A.C. outlet.
Check power cord and
extension cord for loose
fitting plug.
Check for poor connection
at battery and frame. Make
sure connecting points are
clean. Rock clips back and
forth for a better connection.
No problem, this is a normal
condition.