Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FITTING INSTRUCTIONS

Headband
1. Slide out the earcups and tilt the top of the shell out, as the cable must be on the outside of the
headband. (D:1)
2. Adjust the height of the cups by sliding them up or down while holding the headband in place.
Ensure the ear fits within the ear cushion. (D:2)
3. The headband should be positioned across the top of your head to support the weight of the
headset. (D:3)
Fig. D
Helmet Attachment
1. Insert the lower lip of the ARC Connector attachment in the rail entry slot of the ARC
Rail and slide forward to lock into place. Ensure the "square loop" is up. (D:9)
Backband
1. Don the helmet and securely fasten the chin strap.
2. Hold the headset in front of you with the backband below the ear cushions and towards
the user. (D:4)
4. Slide the ear cups under the helmet and over the ears. (D:6)
together, ensuring each ear cushion remains over the ear and is supported by the head strap.
The head strap should be positioned across the top of your helmet. (D:7). Reposition the ear
cushion over the ear as needed. (D:8)
Rendered on 1/23/2020 10:54:14 AM
D:1
D:4
D:7
Page 7
D:2
D:5
D:8
7
34-8725-1903-7 ComTac V manual.pdf
D:3
D:6

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido