4. Settings
4.1 DIP switch settings
230 VAC - Camera
SW1
SW2
SW3
SW4
Label
aes / off / on / on / dc / on / off / on /
on / int / nc
SW1
SHTR
aes: The automatic shutter control (AES)
Shutter
adjusts the amount of light for the CCD-sensor
independently of the iris setting.
This mode should be selected if lenses with
fixed iris or manual iris setting are used.
Remark
At very bright ambient light (e.g. outdoor use) the shutter setting range may not be sufficient
to achieve a satisfactory video quality. In this case it is recommended to use a lens with
automatic iris control ( DC or videosignal controlled).
If pictures are taken with short shutter speed settings intensity level variations may occur.
Pictures taken at artificial light (particularly at fluorescent light) may flicker.
Flare (bright horizontal or vertical lines) may occur in the picture.
If manually controlled lenses are used, problems with the depth of field may occur due to the
fixed iris setting. The depth of field decreases particularly if the iris is opened completely.
This could lead to parts of the picture being out of focus.
SW2
FF
off: Flickerfree mode off
SW3
BLC
on: The picture background may look overex-
posed if the BLC function is activated, parti-
cularly if the object in the foreground is too
small compared to the overall picture (< 40%).
Remark
The iris control is derived from the area at the picture center.
The iris is opened if the picture edges are brighter then the center.
The iris is closed if the picture edges are darker then the center.
SW4
EI Autom.
on: For lenses with fixed or manual iris setting
Shutter
mode (AES)
SW5
A/I Auto Iris dc: For DC voltage controlled lenses
SW6
Y
on: Correction of the contrast curve to achieve
Gamma
a linear response
correction
All manuals and user guides at all-guides.com
SW5
SW6
SW8
SW9
SW7
12 VDC - Camera
SW10
mes / on / off / off / video /off / on / off /
off / L/L / nc
mes: Manual shutter operation. Refer to
table 9 for shutter speed setting.
The shutter has to be switched off if lenses
with video or DC control are used.
on: Flickerfree mode
off: BLC off
off: EI off for DC voltage or videosignal
controlled lenses
video: For videosignal controlled lenses
off: Gamma correction off
18