Connection And Operating - Eneo VKC-1310 Instrucciones De Manejo

3. Connection and Operation
Rear view 12 VDC
D B E
C F G
B PL
C Power supply /
power cord
D LEVEL
P PHASE
E LENS
F 1 ... 8
G VIDEO OUT
HO, Camera mount
HU
N Dust cover
K,L C/CS-Mount
M Locking screw
All manuals and user guides at all-guides.com
230 VAC
D P B E
C F G
LED-indicator B lights green when the camera is switched on.
12 VDC power supply. 12 VDC power supply unit see „Specifications".
230 VAC power supply via power cord C. Make the connections first, then switch
the unit on.
Output level adjustment with potentiometer D for DC controlled lenses.
Potentiometer P for phase adjustment for mains sychronization
(230 VAC camera only)
Connection E for DC- voltage or videosignal controlled lenses. Connect the cable
of lenses with automatic iris control to the supplied 4-pin DIN plug. (Only for
AI lenses which are designed for operation with 9-12 VDC and 50 mA max.)
DIP-Switch F to change the settings described under „DIP-Switch settings".
Video output G (BNC) for connection of external units (e.g. Monitor, 75 Ohm).
1/4"-20UNC-thread HO/HU for camera mounting, for example on a tripod,
ceiling mount or P&T head.
To protect the CCD-sensors the camera module. Always attach dust cover N
when no lens is mounted.
CS-Mount L for CS-Mount-lenses. Insert the supplied C-Mount-Ring K
if C-Mount-lenses are used.
To adjust the flange focus open screw M, turn the at CS-Mount Ring L until the
focus maximum is achieved and fasten the screw again.
16
Side view
K N L M
HO
HU