Building Into A New Hearth - Dovre 2020 Instrucciones De Instalacion Y Uso

The figure below shows an example of the placing of a
stove in a hearth built in accordance with the
instructions given above.
A Existing hearth
B Ventilation space (minimum 15 mm)
C Existing chimney
D Fireproof material or connector
E Opening to prevent pressure build-up

Building into a new hearth

The stove is installed in two stages:
Placing and connecting the stove
Building up the hearth around the stove.
Placing and connecting the stove
1. Put the appliance at the right height and level it.
2. If you are going to put an external casing around
the stove, you should fit the clamping plates
supplied to the sides of the appliance without fully
tightening them. This is because the outside
Subject to change because of technical improvements
All manuals and user guides at all-guides.com
3. Check that there is free convection space of at
4. The masonry may not rest on the stove. Use a
4. Connect the appliance airtight to the flue
5. Check the draught in the flue and the seal of the
Tapping convection air
The appliance is equipped with two additional
connections in order to transport convection heat to
other areas.There must be air grids in these rooms. If
you wish to make use of this function, proceed as
follows:
1. Remove the two push-out plates on top of the
casing fits between the appliance and the
clamping plates; see next figure.
least 15 mm between the existing walls, which
must have the necessary insulation (see chapter
"Installation Conditions"), and the back of the
appliance.
support such as a steel beam, if required. Leave a
clearance of at least 3 mm between the support
and the appliance.
(chimney).
connection on the flue gas duct by making a small,
intense trial fire with newspaper and dry, small
kindling.
In the case of new masonry, wait until the
masonry has dried sufficiently.
convection box by tapping them loose with a
hammer.
9