Burning Wood - Dovre 2020 Instrucciones De Instalacion Y Uso

instead of up the chimney. By lighting the fire in the
way described here, you can avoid this problem.
1. Stack two layers of medium sized logs crosswise.
2. Stack two layers of kindling crosswise on top of
the logs.
3. Place a firelighter cube in the lower layer of
kindling and light the cube according to the
instructions on the packaging.
4. Close the door of the appliance and open the
primary air inlet and the secondary air inlet of the
appliance; see the following figure.
5. Let this fire develop into a good blaze until there is
glowing bed of charcoal. You can then add fuel
and adjust the appliance, see the chapter "Stoking
with wood".

Burning wood

After you have followed the instructions for lighting:
1. Slowly open the door of the appliance.
2. Spread out the charcoal bed evenly across the
bottom of the fire compartment.
3. Stack a few logs on the charcoal bed.
Subject to change because of technical improvements
All manuals and user guides at all-guides.com
Open stacking
If the logs are stacked openly, the wood will burn
quickly as the oxygen can reach each log easily. If
you want to use the stove for a short while, make an
open stack.
Compact stacking
If the logs are stacked tightly, the wood will burn more
slowly as the oxygen can only reach some logs
easily. If you want to burn wood for a longer period,
make a compact stack.
4. Close the door of the appliance.
5. Close the primary air inlet and leave the secondary
air inlet open.
Fill the appliance up to one third capacity.
13