Installation; Preparation; Fitting The Handle - Dovre 2020 Instrucciones De Instalacion Y Uso

The opening direction of the door can be changed.
The appliance is supplied with a door turning to the
right.
The swing direction of the door can be altered. The
appliance is supplied with a left-handed door. For a
right-handed door a locking rod is needed (sold
separately). The instructions for changing the door
swing direction are provided with this locking rod.
The appliance is supplied with a connecting kit for
the outside air supply.
The appliance is not suitable for continuous use.
The insert fireplace has an integrated convection
system. This means that when installing the
appliance it is not necessary for a separate
convection space to be built and the use of air inlet
and outlet grates for convection is not necessary.
The space between the cast-iron fireplace and
steel convection box serves as convection
space. Surrounding air is drawn in at the
bottom of the appliance. The air is directed to
the fireplace where it is heated. The heated air
then leaves the front side of the convection
space through the air opening on the upper side
of the fireplace.
The appliance is equipped with two additional
connections in order to transport convection heat to
other areas.
The appliance is equipped with two built-in fans
that aid convection. The turning speed of the fans
can be adjusted using a speed control. This speed
control is supplied with the appliance. The fan and
speed control are connected to the mains electric
circuit; see paragraph "Connecting fan to the
mains".
The fan works thermostatically. That means
that the fan only starts to operate if the
insert fireplace is sufficiently warm and the
fan switches off once the insert fireplace
has cooled sufficiently.
The appliance can be supplied with an outer frame
to which you can attach a decorative frame. The
decorative frame is supplied as an option.
Subject to change because of technical improvements
All manuals and user guides at all-guides.com

Installation

Preparation

1. Open the door of the appliance.
2. Remove the fire-resistant inner plates.

Fitting the handle

The appliance is supplied with a loose handle, the so-
called "cold hand".
Fit the wooden handle to the adaptor using screw
M8x50 provided; see following figure.
Changing the opening direction of
the door
The opening direction of the door can be changed. The
appliance is supplied with a door turning to the right.
Please check the appliance for damage caused
during transport or any damage or defects
immediately after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.
09-20015.088
7