Building Into An Existing Hearth - Dovre 2020 Instrucciones De Instalacion Y Uso

Follow the instructions below and refer to the next
figure.
1. Unscrew the door latch.
2. Unscrew the closure from the post.
3. Pull the hinge pins out of the hinges.
Be sure to support the door sufficiently; without
the hinge pins, the door can come loose
suddenly.
4. Remove the door from the appliance.
5. Take the closing rings of the hinge lobe and put
them on the other side of the appliance.
6. Position the door above the hinge lobes and insert
the hinge pins into the hinges.
7. Screw the latch onto the other side of the door.
8. Screw the closure onto the other side of the door.
Note: See the "Maintenance" chapter for adjusting the
closing of the door.
Connecting the fan to the mains
The fireplace insert is supplied with two built-in fans
and with a separate revolution control unit. The
appliance is also fitted with a thermoswitch that turns
the fan on and off at a set temperature.
These parts must be connected to the mains as
shown in one of the connection diagrams below.
The connection diagram is specific to the
model.
Have the connection made by a qualified
installer.
The fireplace insert is provided with a three-
core cable.
The fireplace insert must be isolated from the
mains by a 2-pole switch.
Ensure that the stove is properly earthed.
See Annex 2 for extended connection diagrams.
8
All manuals and user guides at all-guides.com
Building into an existing
hearth
To build the stove into an existing hearth, follow the
steps below:
1. Put the appliance at the right height and level it.
2. If you are going to put an external casing around
3. Close the base of the chimney with incombustible
4. Make a 150 mm opening in the base for the
5. Centre the opening in the base on the connection
6. Put the extraction duct in the opening. Make sure
Keep the electrical cable of the appliance free.
the stove, you should fit the clamping plates
supplied to the sides of the appliance without fully
tightening them. This is because the outside
casing fits between the appliance and the
clamping plates; see next figure.
material.
extraction duct.
collar on the stove.
that the duct can be pulled down into the collar.
For example, use a variable-length duct.
If a stainless steel duct is used: Screw the
duct onto the connector supplied, put the
connector into the connection collar and secure
the connector by bending the two lips outward.
Subject to change because of technical improvements