Dovre 2020 Instrucciones De Instalacion Y Uso página 51

4. Rub the glass clean with a dry cloth or kitchen
tissue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.
Lubrication
Although cast-iron is slightly self-lubricating, you will
still have to lubricate moving parts frequently.
Lubricate the moving parts (such as guide
systems,hinge pins, latches and air slides) with
heat resistant grease that is available in the
specialist trade.
Touching up the finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.
Checking the seal
Check whether the sealing rope of the door is still
in good condition and works well. The sealing rope
is subject to wear and needs to be replaced in time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Let the sealant harden fully before you start a
fire in the appliance, because otherwise any
moisture in the sealant will form bubbles in the
sealant and cause a new air leak.
Adjusting the door
Check whether the door closes properly; if necessary,
adjust the hinge post; see next figure.
Subject to change because of technical improvements
All manuals and user guides at all-guides.com
1. Open the door of the appliance; the hinge post is
2. Loosen the two mounting bolts of the hinge post
3. Move the hinge post into the desired position.
4. Use the adjusting screws to adjust the hinge post
5. Tighten the two mounting bolts and check whether
now visible and accessible.
slightly. The mounting bolts are located on the
inside of the stove.
widthwise in the appliance.
the door closes properly.
17