Installation - Hach TL2360 Manual Del Usuario

Ocultar thumbs Ver también para TL2360:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
Figure 2 Instrument components
1 Silicone oil
2 Oiling cloth
3 TL2360 turbidimeter
4 1-inch sample cells (30 mL) with caps (6x)
5 Gelex secondary turbidity standardization kit

Installation

Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
This instrument is rated for an altitude of 3100 m (10,710 ft) maximum. Use of this instrument at an
altitude higher than 3100 m can slightly increase the potential for the electrical insulation to break
down, which can result in an electric shock hazard. The manufacturer recommends that users with
concerns contact technical support.
Installation guidelines
Install the instrument:
• On a level surface
• In a clean, dry, well ventilated, temperature controlled location
• In a location with minimum vibrations that has no direct exposure to sunlight
• In a location where there is sufficient clearance around it to make connections and to do
maintenance tasks
• In a location where the power button and power cord are visible and easily accessible
Connect to external devices (optional)
Use the USB ports to connect the instrument to a printer, barcode handset scanner, USB flash drive
or keyboard. Refer to
(9.8 ft). As an alternative to the touchscreen, use a keyboard to enter text into text boxes on the
display (e.g., passwords and sample IDs).
8 English
Figure 1
on page 7. The maximum length of a connected USB cable is 3 m
6 StablCal Calibration kit
7 Power supply
8 Power cord
9 Dust cover
C A U T I O N

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido