Hand-Bike Axle Adjustment; Helium Pro Axle Adjustment; Footplate Adjustment - Quickie Helium Manual De Usuario

Hand-Bike Axle Adjustment

Hand-Bike-Axle
It is necessary to adjust the hand-bike axle to bias the
centre of gravity rearwards. This allows safe use of a
hand-bike accessory, (Fig.4.10.1).
DANGER!
Using a hand-bike without the hand-bike axle makes the
wheelchair unstable and can lead to serious injury of the
user and other people.

Helium Pro Axle Adjustment

Helium Pro Axle Plate (C.O.G. Adjustment).
To adjust the center of gravity (COG) remove the 2
screws, (A) and move the bracket into preferred
position, (Fig.4.10.2). refit and tighten the screws (5Nm)
Helium Rev.4.0
Adjusting The Footrest
•
•
Releasing the screw (1) will allow you to adjust the
footrest to correspond to the length of your lower leg and
re-attach the footrest. The angle of the footrest may be
individually adjusted by loosening screws (2). The side
protection (3) on the footrest prevents the feet slipping off
accidentally. Make sure that after any adjustment work, all
screws are tightened correctly (see the page on torque)
(Fig. 4.11 - 4.12).
Fig. 4.10.1 Fig. 4.11
High-mount footrest
The high-mount footrest is fitted on the inner part of the
frame and permits a higher footrest position (Fig. 4.13).
Fig. 4.10.2
A

footplate Adjustment

WARNING!
Do not stand on the footboard! Even if the user is
sitting in the chair, there is still a risk of tipping over
1
and injury.
When transferring, do not stand on the footboard,
there is a risk of tipping over and injury.
1
Fig. 4.13
Fig. 4.12
3
2
13