Dell PowerEdge FC830 Manual Del Propietário página 107

1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #1 screwdriver ready.
3. Remove the 2.5-inch hard drive or SSD from the 2.5-inch hard drive or SSD carrier.
Steps
1. Slide the hard drive or SSD into the hard drive or SSD carrier.
2. Align the screw holes on the hard drive or SSD with the holes on the hard drive or SSD carrier.
CAUTION: To avoid damaging the drive or the carrier, do not overtighten the screws.
3. Fasten the four screws to secure the hard drive or SSD to the hard-drive or SSD carrier.
Figure 50. Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier
1. screw (4)
3. hard drive or SSD carrier
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive or SSD carrier
Después de trabajar en el interior de su equipo
Removing a 1.8-inch SSD from a 1.8-inch SSD carrier
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
on page 50
on page 51
on page 51
2. hard drive or SSD
4. screw hole (4)
on page 105
Instalación y extracción de componentes del sled 107