Dell PowerEdge FC830 Manual Del Propietário página 122

Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Removing a 2.5-inch (x6) SATA hard drive or SSD and 2.5-inch (x2) PCIe SSD backplane
Después de trabajar en el interior de su equipo
Removing a 1.8-inch (x16) SAS SSD backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the SSD backplane to replace a faulty SSD backplane or service other components inside the
system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
CAUTION: To prevent damage to the SSDs and the SSD backplane, you must remove the SSDs from the sled
before removing the SSD backplane.
CAUTION: You must note the number of each SSD and temporarily label them before removal so that you can
replace them in the same locations.
4. Remove the SSDs.
Steps
1. Disconnect the power cable from the SSD backplane.
2. Loosen the retention screws securing SSD backplane to the SSD cage.
3. Lift the SSD backplane by its edges until the retention screws disengage from the screw holes on the SSD cage.
4. Remove the SSD cage.
5. Perform the following steps:
NOTE: The 1.8 inch (x16) SSD backplane is a full-length backplane with two backplane cables. The connector on one of
the backplane cables connects the SSDs populated in bays 0-7, to the connector on the system board (J_PERC)
through the expander card. For more information about installing the expander card, see the Expander card section.The
connector on the other backplane cable connects the SSDs populated in bays 8-15, to the connector on the system
board (SATA_BP).
a. Loosen the retention screw securing the backplane cable connector to the connector on the expander card (EXP).
b. Loosen the two retention screws securing the backplane cable connector to the system board connector (SATA_BP).
6. Lift the backplane away from the system.
122 Instalación y extracción de componentes del sled
on page 50
on page 51
on page 51
on page 118