Dell PowerEdge FC830 Manual Del Propietário página 109

Figure 52. Installing a 1.8-inch SSD in a 1.8-inch SSD carrier
a. SSD carrier
b. SSD
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Removing a 1.8-inch SSD from a 1.8-inch SSD carrier
Después de trabajar en el interior de su equipo
Hard-drive or SSD cage
Removing the hard-drive or SSD cage
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the hard-drive or SSD cage to replace a faulty hard-drive or SSD cage or service other
components inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #1 Phillips screwdriver ready.
4. Remove the hard drives or SSDs.
5. Remove the hard-drive or SSD backplane.
Steps
1. Remove the two screws securing the hard-drive or SSD cage to the chassis.
2. Holding the hard-drive or SSD cage by its edges, slide it toward the front of the system and lift it away from the system.
on page 50
on page 51
on page 51
on page 107
Instalación y extracción de componentes del sled 109