Dell PowerEdge FC830 Manual Del Propietário página 134

k. NDC
l. SD vFlash card
m. internal USB key
5. Install an I/O connector cover on the I/O connector(s) at the back of the board.
CAUTION: No levante el conjunto de placa base sujetándola por un módulo de memoria, un procesador u otro
componente.
CAUTION: Temporarily label the hard drive/SSD before removal so that you can replace them in their original
locations.
NOTE: The processor and heat sink can become extremely hot. Be sure the processor has had sufficient time to cool
before handling.
NOTE: The memory modules are hot to touch for some time after the system has been powered down. Allow time for the
memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the
components.
Steps
1. Remove the screws on the system board that secure the system board to the chassis.
2. Lift the system board by its edges and orient it upward.
3. Remove the system board from the chassis by disengaging the USB connectors from the slots on the front wall of the
chassis.
4. Ensure that the I/O connector cover is still in place on the I/O connector at the back of the system board.
Figure 71. Different type of screws on the system board
134 Instalación y extracción de componentes del sled