Dell PowerEdge FC830 Manual Del Propietário página 113

2. Loosen the retention screws securing the hard-drive or SSD backplane to the hard-drive or SSD cage.
3. Lift the hard-drive or SSD backplane by its edges until the retention screws disengage from the screw holes on the hard-
drive or SSD cage.
4. Remove the hard-drive or SSD cage.
5. Loosen the retention screws securing the hard-drive or SSD backplane cable connector to the system board connector.
6. Lift the backplane away from the system.
Figure 55. Removing a 2.5-inch (x8) SATA hard-drive or SSD backplane
1. alignment pin (2)
3. retention screw on the top of the hard-drive or SSD
backplane (4)
5. hard-drive or SSD backplane cable connector
7. retention screw on the bottom of the hard-drive or SSD
backplane (4)
Next steps
1. Install the hard-drive or SSD backplane.
2. Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Installing a 2.5-inch (x8) SATA hard-drive or SSD backplane
Después de trabajar en el interior de su equipo
on page 50
on page 51
on page 51
2. power cable
4. hard-drive or SSD backplane
6. hard-drive or SSD backplane cable
8. screw holes on the hard-drive or SSD cage (6)
on page 114
Instalación y extracción de componentes del sled 113