Dell PowerEdge FC830 Manual Del Propietário página 146

Table 28. System board connectors (continued)
Item Connector
15 BATTERY
16 USB2
17 USB1
18 SATA_BP
19 J_PERC
20 D3, D4, D7, D8, D11, D12
21 J_BP_PWR
22 CPU4
23 D1, D2, D5, D6, D9, D10
24 A1, A2, A5, A6, A9, A10
25 CPU1
26 A3, A4, A7, A8, A11, A12
Disabling a forgotten password
The software security features of sled include a system password and a setup password. The password jumper enables these
password features or disables them, and clears any password(s) currently in use.
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
Steps
1. Turn off the sled using the operating system commands or the CMC.
2. Remove the sled from the enclosure to access the jumpers.
3. Move the jumper on the system-board jumper from pins 1 and 2 to pins 2 and 3.
4. Install the sled in the enclosure.
5. Turn on the sled.
When the sled is on, the power-on indicator is solid green. Allow the sled to finish booting.
The existing passwords are not disabled (erased) until the system boots with the password jumper on pins 2 and 3. However,
before you assign a new system and/or setup password, you must reinstall the password jumper back to pins 1 and 2.
NOTE: If you assign a new system and/or setup password with the jumper on pins 2 and 3, the system disables the new
password(s) the next time it boots.
6. Turn off the sled using the operating system commands or the CMC.
7. Remove the sled from the enclosure to access the jumpers.
8. Move the jumper on the system-board jumper from pins 2 and 3 to pins 1 and 2.
9. Install the sled in the enclosure.
10. Turn on the sled.
11. Assign a new system and/or setup password.
146 Puentes y conectores
Description
Connector for the 3.0 V coin cell battery
USB connector
USB connector
Hard-drive or SSD backplane connector
Storage controller card connector
Memory module sockets (processor 4)
Backplane power connector
Processor socket 4
Memory module sockets (processor 4)
Memory module sockets (processor 1)
Processor socket 1
Memory module sockets (processor 1)