Dell PowerEdge FC830 Manual Del Propietário página 92

Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Installing the optional rSPI card
Después de trabajar en el interior de su equipo
Installing the optional rSPI card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the rSPI card.
CAUTION: To prevent damage to the rSPI card, hold the card only by its edges.
NOTE: You must remove the rSPI card to replace a faulty rSPI card or service other components inside the system.
Steps
1. Align the two screw holes on the rSPI card with the standoffs on the system board.
2. Install the two screws to secure the rSPI card to the system board.
Figure 33. Installing the rSPI card
1. screw (2)
3. standoff (2)
Next steps
Follow the procedure listed in the After working inside your system section.
92 Instalación y extracción de componentes del sled
on page 50
on page 51
on page 92
on page 51
2. rSPI card
4. connector