Dell PowerEdge FC830 Manual Del Propietário página 86

Replacing an SD card
Prerequisites
CAUTION: Muchas de las reparaciones deben ser realizadas únicamente por un técnico de servicio autorizado. El
usuario debe llevar a cabo únicamente las tareas de solución de problemas y las reparaciones sencillas
autorizadas en la documentación del producto o indicadas por el personal de servicio y de asistencia en línea o
telefónica. Los daños causados por reparaciones no autorizadas por Dell no están cubiertos por la garantía. Lea y
siga las instrucciones de seguridad que se envían con el producto.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Enter the System Setup and ensure that the Internal SD Card Port is enabled.
CAUTION: When an SD card failure occurs, and the Internal SD Card Redundancy option in the Integrated
Devices screen of the System Setup is set to Mirror Mode, there may be loss of data. To avoid data loss, follow
step 4 through step 6 of the Troubleshooting an Internal SD Card section.
NOTE: The SD card in the lower card slot is the primary card (SD1) and the SD card in the upper card slot is the secondary
card (SD2).
NOTE: When an SD card failure occurs, the Internal SD Card Redundancy option in the System Setup is set to Disabled
and the internal dual SD module controller notifies the system. On the next reboot, the system displays a message indicating
the failure.
NOTE: If the Internal SD Card Redundancy option is set to Disabled, replace the failed SD card with a new SD card.
Steps
1. Locate the SD card slot on the internal dual SD module (IDSDM) card.
2. Press inward on the card to release it from the slot, and remove the card.
Figure 27. Replacing an SD card
1. IDSDM card
3. upper card slot (SD 2)
Next steps
1. Follow the procedure listed in the After working inside your system section.
86 Instalación y extracción de componentes del sled
2. SD card
4. lower card slot (SD 1)