Removing The Guard - Stanley FATMAX FMEG232 Traducido De Las Instrucciones Originales

ENGLISH (Original instructions)
Injuries caused when changing any parts, blades or ac-
u
cessories.
Injuries caused by prolonged use of a tool. When using
u
any tool for prolonged periods ensure you take regular
breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms, along with the date code, are shown
: on the tool:
Warning! To reduce the risk of injury, the user must
O read the instruction manual.
Wear safety glasses or goggles when operating this
N
tool.
Wear ear protection when operating this tool.
Electrical safety
#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised STANLEY FATMAX
Service Centre in order to avoid a hazard.
8
Voltage drops
Inrush currents cause short-time voltage drops. Under
unfavourable power supply conditions, other equipment may
be affected.
If the system impedance of the power supply is lower than
0.107 Ω, disturbances are unlikely to occur.
Features
This tool includes some or all of the following features.
1. Switch
2. Spindle lock
3. Guard
4. Side handle
Purpose of design
This angle grinder is designed especially for grinding.
Do not use sandpaper discs and grinding wheels other than
those with depressed center.
Do not use the tool in wet conditions or environments in the
presence of flammable liquids or gases.
This angle grinder is a professional power tool.
Do not allow children to come in contact with this tool.
Inexperienced operators are required to use this tool under
supervision.
Assembly
Warning! To minimize the danger of serious personal
injury, please switch off the tool power and disconnect all
plugs before adjusting or removing/installing any
accessory. Before reassembling the tool, press and release
the trigger switch to make sure the tool is already switched off.
Attaching and removing the wheel guard
(Fig. A)
Warning! To minimize the danger of serious personal
injury, please switch off the tool power and disconnect all
plugs before adjusting or removing/installing any
accessory. Before reassembling the tool, press and release
the trigger switch to make sure the tool is already switched off.
Attaching the guard
Place the angle grinder on a work bench, groove facing
u
up.
Bring the flange of the guard (3) collar over the groove (5)
u
of the gear housing.
Turn the guard (3) counterclockwise by 150 degrees.
u
Make sure that the screws (20) are tightened.
u

Removing the guard

Loosen the screws (20) on the guard collar.
u
Pull up the guard (3).
u
Warning! Do not operate the tool when the safety
guard is not in place.