Bahco TAWM Serie Traducción De Las Instrucciones Originales página 14

TAWM SERIES
Note: If wrench is Locked (see Preset Lock in Advanced section) Clear count function is disabled.
LANGUAGE
1. To select the language menu, press the ENTER button while LANGUAGE is highlighted then
highlight the desired language and press the ENTER button.
2. Decimal Mark selection menu is displayed. Decimal separator can be a comma or decimal point.
Use UP/DOWN buttons to select the decimal separator then press the ENTER button.
Note: The decimal separator will affect the formatting of the downloaded data when opened by
Excel depending on Windows
STD
SLIM
3. To exit Main menu and return to target torque or angle screen, press ENTER button while EXIT
menu selection is highlighted.
TARGET PRESETS (PSET)
PSET function gives user ability to configure 50 preset target torque or target angle settings, each with
a target, minimum, maximum (over range) and batch count value. PSETs are stored in non-volatile
memory so that they are retained while power is off.
Note: After adding a Preset (see below), navigate between manual target torque, angle mode
and PSET screen by repeatedly pressing ENTER button. While PSET screen is displayed, press
UP/DOWN buttons to select additional configured PSETs.
regional settings.
®