Data Download - Bahco TAWM Serie Traducción De Las Instrucciones Originales

Llave dinamométrica electrónica con lectura de par, ángulo y memoria
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 563
ANGLE MODE
Note: When angle measurement mode is selected for first time following a power on, "ANGLE
ZERO REQUIRED" message is displayed. After two seconds angle zero process begins and
wrench must be placed on a stable surface. If ENTER button is pressed before two seconds to
change to torque only mode, angle zero process is skipped.
1. Set target. Use UP/DOWN buttons to change target ANGLE value.
2. Apply Torque and Rotate Wrench. Grasp center of handle and slowly apply torque to fastener and
rotate wrench at a moderate consistent speed until progress lights display green and a ½ second
audible alert and handle vibration alerts you to stop.
3. Release torque. Note alternating peak TORQUE and ANGLE readings flashing on LCD display for 5
seconds. Pressing BACKLIGHT button while peak values are flashing will continue to display values
until button is released. Momentarily pressing UP/DOWN, ENTER or UNITS button will immediately
return to target ANGLE screen. Reapplying torque (ratcheting) before target screen is displayed will
continue ANGLE accumulation as wrench is rotated.
4. Recall Peak ANGLE Reading. To recall last peak ANGLE measurement, press and hold BACKLIGHT
button for approximately 3 seconds. Peak TORQUE and ANGLE will be displayed alternately for 5
seconds.
MODE CYCLE COUNT
Mode cycle count feature is used to indicate number of times wrench has reached target torque in
torque measurement mode or target angle in angle measurement mode.
STD / SLIM
TORQUE AND ANGLE MODE CYCLE COUNTING
1. Numerical counter located in top right of target torque or target angle screen will increment after each
torque or angle cycle if applied torque or angle has reached target value.
2. When toggling between torque mode or angle mode using ENTER button or if target is changed,
numerical counter will reset back to 00. counter WILL NOT reset when re-zeroing, on menu entry/
exit or power down.
3. Memory icon will turn on indicating at least one torque or angle cycle data has been stored in memory.

DATA DOWNLOAD

Torque and Angle data in memory can be downloaded to a computer via USB port.
Note: When downloading data from a wrench that has previous downloaded data, rename
previous file or move it to a different directory to prevent overwrite. However, Windows
notify user of duplicate file names and allow user to skip download, overwrite existing file or
save new file as a second copy.
will
®
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tawm38135Tawm12340Taw м 348 00

Tabla de contenido