Bahco TAWM Serie Traducción De Las Instrucciones Originales página 23

TOGGLE BACKLIGHT SETUP
This function will allow user to enable or disable backlight toggle function. If toggle mode is disabled,
BACKLIGHT button turns on backlight and it automatically turns off after five seconds following any last
button press. If toggle mode is enabled, a BACKLIGHT button press will turn on backlight and it will
remain on until next BACKLIGHT button press.
1. From Settings menu, use UP/DOWN buttons to highlight TOGGLE BACKLGHT selection then press
ENTER button.
2. TOGGLE BACKLGHT screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE or DISABLE (factory default) selection.
4. Press ENTER button to accept selection and exit to Settings menu.
Note: Backlight will turn off when wrench powers down either by POWER button press or sleep time.
Note: If toggle backlight is enabled and backlight is on, backlight will remain on during and after
applying torque.
STD
VIBRATOR CONFIGURATION
This function will allow user to configure vibrator for On or Off when target is reached for preference
and/or battery power savings.
1. From Settings menu, use UP
press ENTER button.
2. VIBRATOR CONFIG screen is displayed.
3. Use UP /DOWN
4. Press ENTER button to accept selection and exit to Settings menu.
/DOWN buttons to highlight VIBRATOR CONFIG selection, then
buttons to toggle ON or OFF selection.
SLIM
23