skilsaw SPT5007-EA Manual De Instrucciones página 9

ATTACHING THE EARLY ENTRY
ATTACHMENT
1. Set the saw on its side on a flat surface with
the blade guard facing up .
2 . Attaching rear part.
Align the rear knob of the early entry attach-
ment with the stud of the torsion spring as-
sembly, then tighten the rear knob . The
below points need to be observed (Fig. 7):
• Ensure that the long end of the torsion spring
is inserted into the opening of the block .
• Ensure that the end of the stud is flush with
the stepped inner surface of rear knob .
Assembly
FIG. 7
Block
Ensure that the long end of the
torsion spring is inserted into the
opening of the block .
-9-
End of the
stud
Stepped
inner surface