▸
Flailing hoses can cause serious injuries.
Therefore always check whether hoses and their
fastenings are undamaged and have not come
loose.
▸
Direct cold air away from the hands.
▸
Do not use quick-release couplings at the tool
inlet with impact and impulse drives. Only use
threaded hose connectors made from hard-
ened steel (or a material of comparable impact
strength).
▸
Ensure that the maximum pressure indicated on
the tool is not exceeded.
Intended use
The device may only be used for screwing in and
screwing out of screws in wood, metal and plastics.
The device must only be operated using compressed
air. The device is not suitable for use as a lever,
breaking or striking tool. The device is designed for
use with genuine Würth system accessories.
Any other use or use outside this scope is considered
improper use.
The user alone is responsible for damage
resulting from improper use.
Symbols on the device
Symbol
WARNING
Special safety instructions
Meaning
Read the operating instruc-
tions!
Wear suitable ear protec-
tors!
Wear protective glasses.
▸
If universal rotational couplings (claw couplings)
are used, lock pins must be used together with
whip-check hose clips to provide protection in the
event of failure of the hose connection to the tool
or of connections between hoses.
▸
For torque-controlled tools with continuous rota-
tion, the air pressure has safet relevant e ects
on the performance. Therefore hose length and
diameter re uirements must be specified.
▸
Never carry air tools by the hose.
Device elements
Overview [Fig. I]
1 Switch (on/o )
2 Tool holder
3 Switch (torque)
4 Direction of rotation
5 Handle
6 Compressed air connector
7 Hose connector (Würth system accessory)
8 Hose clamp (Würth system accessory)
9 Compressed air hose (Würth system accessory)
Technical Data
Item no.
Square tool holder
Idle speed
Maximum torque
Compressed air threaded connector 1/4"
Average air consumption
Min. hose diameter
Operating pressure (max.)
Weight
5714 308 X
1/2"
9 000 min-
1
750 Nm
135 l/min
9 mm
6.3 bar
1.1 kg
15