Safety Advice - Parkside PDEXS 150 A1 Instrucciones De Utilización Y De Seguridad

Speed:
Sanding stroke:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Vibration emission value = 6.8 m / s
Uncertainty K = 1.5 m / s 2
Values determined in accordance with EN 28662-1;
EN ISO 8662-8

Safety advice

read all the safety advice
and instructions. Even minor failures to observe
the safety advice and instructions could lead to se-
vere injury.
Keep all the safety advice and instructions
in a safe place for future reference.
Check the device for damage before
bringing it into use. Do not use the device
if you discover any defects.
Keep children and other people
away while you are operating
the sandblasting gun. Distractions
can cause you to lose control of the device.
Ensure that the power tool
does not come into contact in
any way with sources of
electric power as it is not insulated.
The power tool is not generally insulated for
coming into contact with electric cables;
Wear protective gloves. Failure
to observe this advice could result
in cutting injury!
Keep your hands, hair and clothing
away from the moving end of the
power tool. Failure to observe this advice
risks drawing in and trapping and could result
in injury.
All manuals and user guides at all-guides.com
10500 min
-1
5 mm
89 dB(A)
100 dB(A)
2.5 dB
2
Introduction / Safety advice
For your own safety, wear
suitable personal protective
equipment.
Wear an approved dust
mask / protective hood!
Wear protective glasses!
rISK OF EXPLOSIOn! Do not
use the air sander in environments
containing gases, open flames, fires
or gas-operated water heaters.
nO SMOKInG!
Work in adequately ventilated spaces
only.
never use oxygen or other combustible
gas as the energy source.
never exceed the maximum working air
pressure of 6.3 bar.
Ensure that the compressed air supply
hose cannot wave around in an uncon-
trolled manner. Failure to observe this
advice could result in injury.
Do not use grinding wheels or cutting
discs.
Check that the maximum operating
speed of the machine tool attachment
(backing plate, sanding belt, fibre
grinding disc etc.) is higher than the
specified speed of the power tool.
Self-adhesive sanding sheets must
be attached concentrically on to the
backing plate.
release the trigger / operator's lever
if there is an interruption in the mains
power supply.
Use only the lubricant (pneumatic oil)
recommended by the manufacturer.
never touch the rotating parts while
the device is operating. Failure to observe
this advice could result in injury.
rECOIL FOrCES! High
working pressures can give rise to recoil forces
that under certain conditions can result in
danger from continuous loading.
GB/MT 31