Instruction For The User; Igniting The Pilot Burner; Igniting The Burner; Switching Off - MBM MINIMA Serie Instrucciones Para La Instalación, El Uso Y El Mantenimiento

5.
Premise
Before operating the unit, thoroughly wash the inside of tub with hot water and detergent, then rinse accurately.
Never use salt around the Bain-Marie, as this may cause rust at the bottom.
Attention
Never operate the unit without having filled the tub in with water. Non-compliance with this indication would cause bad
damages due to overheating at tub bottom or to functional elements. Frequently check the water level.
5.1

IGNITING THE PILOT BURNER

- To ignite the pilot burner, press the knob (Fig. 5) turning it to the left to reach the symbol (
position, press the knob deeply down and at the same time push the piezoelectric ignition button on the panel (Z Fig. 4).
- The pilot, visible through the peephole on the panel (S Fig. 4), will light up; keep the knob pressed for approx. 15 seconds
and then release it. Should the pilot go off, repeat the ignition operation.
5.2

IGNITING THE BURNER

- To ignite and adjust the burner, turn the knob (Fig. 5) to the desired position, remembering that the following temperatures
correspond to the positions from 8 to 1:
THERMOSTAT
POS. 8
POS. 7
POS. 6
POS. 5
POS. 4
POS. 1-3
5.3

SWITCHING OFF

- To switch off the burner, return the knob (Fig. 5) to position (
N.B. You need a maximum time of 55 mins. to bring the "full" Bain-Marie to approx. 70°C; running consumption at 80°C
2
is approx. 32Whr/dm of water surface.
5.4

WATER DISCHARGE FROM THE BASIN (PIC. 4)

To discharge the water from the basin of bain marie, take the 90° extension pipe together (P) with a container and put it in the
protraction of the tap, sticking it as it is represented in the picture. Open the tap by means of the lever (M).
After discharging the basin, close the tap bringing the lever (M) to the intial position.
6.
- Clean the stainless steel parts daily with soapy lukewarm water, then rinse well and dry thoroughly.
- Absolutely avoid to clean the stainless steel with common steel-wool, or common steel brushes and scrapers, as they may
discard ferrous particles which, on depositing, cause rust spots. You may, if you like, use stainless steel-wool passed on
following the butter-finish direction.
- Should the unit remain unused for long periods, heavily rub all the steel surfaces with a cloth slightly wetted with vaseline
oil, in order to cover them with a protective film. Periodically ventilate the premises.
- Absolutely avoid continuous or intermittent contact with ferrous material, in order not to cause galvanic corrosion
reactions.
Therefore ladles, turners, spoons, skimmers, etc. should be made of stainless steel.
- Once the tub is drained, thoroughly wash it so as to remove any incrustations, preferably using nylon brushes.
ATTENTION
Should the unit remain inactive for long periods, do not leave water in the container.
The manufacturer shall not be liable for damages caused by non-compliance with the above mentioned maintenance
instructions.
CONTAINER GN with 10-20 ltr.
= 85 °C
= 75 °C
= 65 °C
= 55 °C
= 45 °C
= 40 °C
- 19 -

INSTRUCTION FOR THE USER

); for total shutoff, return the knob to position ( ).

MAINTENANCE AND CLEANING

); having reached this
GB