Use Instructions - STAMOS S-DIGITRON 200P Manual De Instrucciones

13. CONNECTION OF OUTPUT SIDE
Connection of parent metal cable
• Please use the attached connector to
connect the parent metal cable to the
positive OUT end.
Connection of the cable on the side of the
electrode holder
• Please use the attached connector to
connect the electrode holder cable to
the negative OUT socket.
Connection of the aviation socket side
• Please use the attached plug to con-
nect the cable of the manual switch to
the aviation socket.
Connection of water-passing fast plug
• Please use the attached plug to con-
nect the air connector of the welding
gun to the water- passing fast plug.
EN
Rev. 25.04.2019
60
60

14. USE INSTRUCTIONS

Operation Before And After Welding
Preparation Before Operation
DANGER
• If the welding operation is conducted in small and badly ventilating area, it may
lead to the oxygen deficiency and even make people suffocated.
• The fume intake during welding is very harmful to the human body; be sure
to provide fume exhaust and air exchange methods or use the respiratory pro-
tective device.
During operation, be
sure to use protective
devices to protect you
!
and others from being
damaged by the arc,
WARNING
splash, noise, etccaused
by welding.
• Wear the special protective clothes, such as gloves, safety boots, etc to protect
eyes and the exposed skin.
• Please prepare shades or use protective masks with shadow shield.
• After connection is over, check if the following connections are completed.
Parent metal: Earth wire
Welding machine: Grounding terminal earth
• Power on
Turn the switch of the power distribution box on and then turn on the switch of
this device
Rev. 25.04.2019
EN
During operation, be sure to use pro-
tective devices or air exhaust system to
protect you and others from being dama-
ged due to the welding fume and ensure
sufficient oxygen supply.
61