Safety Warnings And Precautions - STAMOS S-DIGITRON 200P Manual De Instrucciones

SAVE THIS MANUAL
Keep this manual for the safety warnings and precautions, assembly, operating, ins-
pection, maintenance and cleaning procedures. Write the product's serial number in
the back of the manual near the assembly diagram (or month and year of purchase if
product has no number). Keep this manual and the receipt in a safe and dry place for
future reference.
IMPROTANT SAFETY INFORMATION
In this manual, on the labeling, and all other information provided with this
product:
This is the safety alert symbol. It is used to alert you to potential personal
injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will result in death
or serious injury.
WARNING: WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION: CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, could result in minor or moderate injury.
NOTICE: NOTICE is used to address practices not related to personal injury.

SAFETY WARNINGS AND PRECAUTIONS

WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed below may result in electric shock, fire, and/or
serious injury.
SAVE THESE INSTRUCTIONS
EN
Rev. 25.04.2019
38
38
Work Area Precautions
1. Keep your work area clean and well lit. Cluttered benches and dark areas
invite accidents.
2. Do not operate power tools in explosive atmospheres, such as in the pre-
sence of flammable liquids, gases, or dust. Power tools create sparks which may
ignite the dust or fumes.
3. Keep bystanders, children, and visitors away while operating a power
tool. Distractions can cause you to lose control. Protect others in the work area
from debris such as chips and sparks. Provide barriers or shields as needed.
Electrical Safety
1. Grounded tools must be plugged into an outlet properly installed and
grounded in accordance with all codes and ordinances. Never remove the
grounding prong or modify the plug in any way. Do not use any adapter
plugs. Check with a qualified electrician if you are in doubt whether the
outlet is properly grounded. If the tool should electrically mal function or break
down, grounding provides a low resistance path to carry
electricity away from the user.
2. Double insulated tools are equipped with a polarized plug (one blade is
wider than the other). This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install a polarized outlet. Do not
change the plug in any way. Double insulation eliminates the need for the three
wire grounded power cord and grounded power supply system.
3. Avoid body contact with grounded surfaces such as pipes, radiators,
ranges, and refrigerators. There is an increased risk of electric shock if your body
is grounded.
4. Do not expose power tools to rain or wet conditions. Water entering a
power tool will increase the risk of electric shock.
5. Do not abuse the Power Cord. Never use the Power Cord to carry the
tool or pull the Plug from an outlet. Keep the Power Cord away from heat,
oil, sharp edges, or moving parts. Replace damaged Power Cords immedia-
tely. Damaged Power Cords increase the risk of electric shock.
Rev. 25.04.2019
EN
39