Sony HT-SS370 Guía De Instalación Rápida página 27

The table below shows the display when
measurement starts.
Notes
• If "CHECK MIC" appears, you cannot perform
the Auto Calibration. Connect the optimizer
microphone, then perform the Auto Calibration
again.
• If "PHONES" appears, you cannot perform the
Auto Calibration. Disconnect the headphones
from the S-AIR product you are using, then
perform the Auto Calibration again.
Tips
• When Auto Calibration starts:
- Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
- Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
.- Press
1/(9
or MUTING.
- Press input buttons on the remote or INPUT
SELECTOR
+1- on the receiver.
- Change the volume level.
•
C)
1
CD
Confirm the measurement
a
result.
~
CQ
When the measurement ends, a beep
en
-
m
sounds and the measurement result
...
-
C D
appears on the display.
Q.
Measurement Display Explanation
result
When the SAVE Proceed to step
measurement EXIT 2.
process
completes
properly
When the ERROR
See "When
measurement
XXXX
error codes
process fails
appear" (page
28).
2
Press
+'+
repeatedly to select
the item, then press
8.
Item Explanation
SAVE EXIT
Saves the measurement
results and exits the setting
process.
WRNCHECK Displays warning
concerning the
measurement results. See
"When you select "WRN
CHECK"" (page 28).
DISTINFO Displays the measurement
result for speaker distance.
LEVEL INFO
Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
Display
SUBWOOFER
T. S.P.
TONE
Measurement for
Speaker gain, distance,
frequency response
Speaker existance
Subwoofer gain and
distance
Note
After "SAVE EXIT" is displayed for 50
seconds, the measurement result is saved
automatically, without the need to save the
procedure.
3
Save the measurement result.
Select "SAVE EXIT" in step 2.
The measurement results are saved.
continued--------
27
US ·