Remote Commander - Sony HT-SS370 Guía De Instalación Rápida

Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
Outdoor FM antenna
Receiver
FM
750
COAXIAL
Ground wire
(not supplied)
+
To ground
Radio stations cannot be tuned in.
• Check that the antennas are connected
securely. Adjust the antennas and connect
an external antenna, if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Change to monaural reception
(page 35).
• No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 37).
Remote commander
The remote does not function.
• Point the remote at the remote sensor on
the recei ver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
Others
The POWER/ACTIVE STANDBY
indicator flashes.
• The receiver is in protection mode. Tum
off the receiver and tum it on again.
The receiver is turned off
automatically.
• The AUTO STBY function is working
(page 62).
•
-
: ;,
0' ...
3
m
:=
o
:;,
continued------
71
us