Connecting The Camera - Waeco PerfectView CAM26W Instrucciones De Montaje Y Uso

_RV-26.book Seite 36 Montag, 7. Mai 2007 2:28 14
Mounting the camera
Attaching the camera and camera guard
Caution!
a
Never mount the camera without the additional camera guard.
To mount the camera guard, only use the supplied M4 x 10 mm
screws. Longer screws will damage the camera.
➤ Push the camera into the bracket (fig. i, page 7).
➤ Push the camera guard (fig. 8 3, page 5) over the camera holder.
➤ Fasten the camera guard and the camera loosely using the two
M4 x 10 mm screws in the fixing hole (fig. i, page 7).
Caution!
a
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
The camera is now centred.
➤ Align the camera so that the lens points straight down to the road.
Note!
I
The four screws are only tightened when you have aligned the
camera (see chapter "Checking the function and setting
the camera" on page 37).
To do this you must first install and connect a monitor (see principle
circuit diagram fig. k, page 8).
7.3

Connecting the camera

Note!
I
Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable
(fig. 0 A, page 6).
36
All manuals and user guides at all-guides.com
PerfectView CAM26W