Tabla de contenido
Publicidad
For this use the button [8] must be placed in position
For use of the "Goblin" as a fall-arrester device for the safety line while working on a rope, the device
and 11 mm. Always connect to an attachment point for fall arrest (A) of an EN 361 full body harness. The
connection can be made with a connector (
slides freely on the rope, following the operator's movements. In case of an extended stay at the same work point,
the device can be taken to a position higher than the operator and then lock it, placing the button [8] in position
(
). If the safety line is used to suspend the operator, it becomes, for all intents and purposes, a work line and
therefore an additional safety line must be used for optimum safety of the worker. In the event of dynamic loads on
the device, this could cause damage to the rope sheath and therefore it must be thoroughly inspected. In the event
of a major fall, the device and the rope must be replaced. To calculate the minimum clearance distance, refer to
and chart A.
For this use the button [8] must be placed in position
EN 361 full body harness. The use of a sternal attachment point is preferable over a dorsal one. The connection
(
358 harness. To calculate the minimum clearance distance, refer to
terraces with the risk to fall over the edge (
For this use the button [8] must be place in position
For use of the "Goblin" as an ascender for the working line in rope access, the device must be combined exclusively
attachment point of an EN 813 sit harness. The connection must be made through EN 362 connectors and EN 354
lanyards, with total maximum length of 1 m (
positioning of an EN 358 harness. Always use combined with a safety line with a type A adjustment device.
EAC Use
instructions of EN use.
RESCUE USE
Summary
CAMP "Goblin" is a safety line adjustment device for rescue in rope access by two people, for use in combination
Use
For this use the button [8] must be place in position
To use "Goblin" as a safety line adjustment device while conducting rope access rescue, the device must always
), rope should be adequately protected. Side movements should be
). Do not connect the device to the attachment points for work
.
35
). Do not connect the device to the
and chart A. For the use on roofs or
Publicidad
Tabla de contenido
