Goodyear GY 13RT Manual De Usuario página 58

English • Owner´s manual
ATTENTION
- The engine must be off when the handle-bar is be turned.
- Make sure that the handle-bar is well fixed on its turning stop before beginning work.
- When the handle-bar is turned, always position the reversing lever according to the running direction
to enable the reversing safety device to operate correctly.
3) After having turned the handle-bars through
180°, move the release lever (8) forwards in the
running direction.
4) Fit the gearshift rod (1) and PTO control rod
(2) back in place along with their respective
components in the new positions, which are
exactly opposite to the previous ones (Fig. 16).
5) After having turned the handle-bars to
the required running direction, remember to
move the reverse shuttle lever (12) in the same
direction (Fig. 16).
Adjusting track
The track of the walking tractor may vary depending on the type of wheel used:
1) Wheels with fixed discs (Fig. 17)
Wheels with fixed rims are attached to the
wheel hub with four bolts (A) and the track can
be varied by setting the right wheel left and
vice versa. Make sure that the direction of the
tyre ribbing tread is kept in the correct forward
direction.
2) Wheels with adjustable discs (Fig. 18)
Wheels of this type have adjustable rims. Track is
adjusted by means of the (Z) on disc (C), which
can be moved inside or outside lip (D) which
remains fixed to the wheel hub. Disc (C) is fixed
to lip (D) by bolts (E) thus, if the track is varied,
make sure that the tyre ribbing faces the right
forward direction.
58
FIXED DISC TRACKS
TYPE OF TYRE
6.5/80-12
5.00-12
TRACK
MIN.
450
400
Fig. 16 -
Turning the
handle-bars.
Fig. 17 - Whe-
els with fixed
discs.
MAX.
500
540
Fig. 18 -
Wheels with
adjustable
discs.