WIKA TC52-M Manual De Instrucciones página 17

5. Commissioning, operation
5.1.6 Cladding installation
A section of cladding must be installed over the magnet to provide environment protection.
The section of cladding is approximately 200 x 200 mm [8 x 8 in]. The middle of the
cladding section must have a hole to fit over the neck of the magnet assembly.
EN
Place the section of cladding over the neck of the magnet assembly. Secure the cladding in
place using self tapping screws.
WIKA operating instructions model TC52-M 17